The User may not reserve engineer, decompile, disassemble, nor otherwise attempt to discern the source code of this Software.
The User may not rent, lease, sub-license nor assign this Software to any third party without prior written consent of OMRON.The User may not distribute copies of this Software to third parties.If the User modifies this Software, OMRON assumes no responsibility for the results of any modifications made by the User, including defects or damages of any nature. The User shall not modify any portion of this Software.DESCRIPTION OF OTHER RIGHTS AND LIMITATIONS The User must not remove or alter any copyright notices on all copies of this Software.The User may copy this Software for back-up purpose only, provided that the User shall include all of the original proprietary notices in the obvious way.
LICENSE AGREEMENT OMRON grants the User a non-exclusive and limited license to use this Software on only computers owned by the User within the number of contracted licenses.Definition This Software used in this agreement includes computer software, CAD data, computer programs, sample data, associated media, printed materials such as manuals, "online" or electronic documentation, and so on.
Software License Agreement This is a binding agreement between the User and OMRON on the terms and conditions of the license of this Software. If the User does not agree to these terms and conditions, do not install, copy, or use any file of this Software. By installing, copying, or otherwise using this Software, the User agrees to be bound by the terms and conditions of this Software. This Software License Agreement is a legal agreement between the User and OMRON Corporation (hereafter, called “OMRON”). You (either an individual or a legal entity, hereafter called “User”) may use this software (hereafter called “this Software”) only when User agrees to the Software License Agreement below (hereafter called "this agreement"). Searching through the help files, I can't find anything on this setting.
I figured that the Auto Detect would override this setting, but unless my IP Address ends in 15, I cannot go online. This was set to 15, yet the "Auto-Detect" box was checked. Then I noticed an option under the "Network Settings" called Workstation Node Number. But when I tried to go online, I could ping the IP Address, but could not connect to the PLC using CX-Programmer.Īfter reading a bunch of help files and searching around various forums, I was at a loss. They have an Ethernet card in their I/O configuration, CS1W-ETN11. I inherited a couple machines using Omron CS1G-CPU42H PLCs.